Hypertherm Powermax105 Service Manual - Manual (Page 264)

Power SuPPly ComPonent rePlaCement
9-66
powermax
105 Service Manual
5. Disconnect the 90° push-to-connect fitting by pushing in the plastic ring (closest to the brass nut) and pulling the
fitting away from the nut.
6. Disconnect the electrode wire and two output inductor wires by removing the brass nut that secures the ring
terminal to the quick disconnect receptacle.
Note: The electrode wire and two output inductor wires are captured in the same wire connector.
7. Remove the plastic washer.
Upper grommet
90° push-to-connect
fitting
Brass nut
Torch interface
cable
Quick disconnect
receptacle
Nozzle wires (2) Electrode wire
Plastic washer
Output inductor
wires (2)
Protective
sheathing