Hypertherm Powermax105 Service Manual - Manual (Page 221)

Power SuPPly ComPonent rePlaCement
powermax
105 Service Manual 9-23
1. Secure the voltage divider board to the right of the power supply fan by tightening two of the supplied screws to
11.5 kg cm (10 in.-lbs).
Plastic CPC plug
on rear panel of
power supply
2. Remove the round plastic plug that covers the CPC opening in the rear panel.
Install the machine interface cable with voltage divider board
Voltage divider board with CPC port and cables
Screws (075534)
Right grommet Solenoid valve