Hypertherm Powermax105 Service Manual - Manual (Page 48)

Basic system OperatiOns
3-4
powermax
105 Service Manual
Status screen
The status screen shows system status and fault information.
Torch started
Fault icon
Fault code
Torch is cutting
Remote
connected
Electrode end of life
detection manually disabled Current setting (amps)
Current selection cursor
Pressure selection cursor
Pressure
setting
Visual pressure
setting
gas pressure indicators
In manual mode, the gas pressure is displayed in bar and psi. The gas pressure bar is also a visual indicator of the gas
pressure.
gas pressure bar
When the arrow is centered in the vertical bar (the reference pressure of the automatic pressure setting), the
gas pressure is set to the preset (factory-defined) value. If the pressure is higher than the preset value, the
arrow appears above the mid-point of the bar. If the pressure is lower than the preset value, the arrow appears
below the mid-point of the bar.
Note: In automatic mode, the power supply adjusts the pressure to the preset value. You can use manual
mode to adjust the pressure to satisfy the needs of a particular cutting job. Refer to page 3-10
Manually adjusting the gas pressure.
System status icons
The screen displays icons to indicate the system’s status.
torch started
Indicates that the torch has received a start signal.
torch is cutting
Indicates that the cutting arc has transferred to the metal and the torch is cutting.
Remote control
Indicates that a remote control or CNC is controlling the power supply using serial communications. All local
controls are disabled.
Electrode end-of-life detection manually disabled
Indicates that the electrode end-of-life detection feature is manually disabled.