Hypertherm Powermax105 Service Manual - Manual (Page 230)

Power SuPPly ComPonent rePlaCement
9-32
powermax
105 Service Manual
Disconnect the gas tube
1. Push in the plastic ring on the push-to-connect fitting.
2. Gently pull the top of the rear end panel away from the power supply until the gas tube pulls out of the push-to-
connect fitting.
Connect the gas tube
1. Align the end of the gas tube with the push-to-connect fitting.
2. Gently push the top of the rear end panel toward the power supply until the gas tube is fully seated in the push-to-
connect fitting.
Push-to-connect
fitting
Gas tube
Plastic ring
Rear end panel