Hypertherm Powermax105 Service Manual - Manual (Page 298)

Torch componenT replacemenT
10-8
powermax
105 Service Manual
Left handle
Strain relief
Strain relief
Left handle
Remove the left handle
1. Remove the consumables from the torch.
2. Place the torch on a flat surface with the left handle facing up.
3. Use a T10 TORX screwdriver or a flat-blade screwdriver to remove the five handle screws from the left handle.
4. Carefully lift the left handle away from the torch.
Note: You should wear eye protection as the trigger spring can launch out of the handle.
Duramax 75° hand torch
Duramax 15° hand torch
Install the left handle
1. Align the left half of the handle with the right half.
Note: If replacing the handles, apply the “H” label to the left side of the torch handle.
2. Verify that both trigger pivots are located in the trigger pivot holes (one pivot hole in each half of the handle). Make
certain the wires are not pinched by the handles and that the strain relief is held in place by the handles.
3. Use a T10 TORX screwdriver or a flat-blade screwdriver to tighten the five handle screws to 14.98 kg cm
(13.0 in.-lbs).
4. Install the consumables.