Hypertherm Powermax105 Service Manual - Manual (Page 263)

Power SuPPly ComPonent rePlaCement
powermax
105 Service Manual 9-65
Replace the torch quick disconnect receptacle
1. Unplug the wire connector from the J17 power board socket.
2. Disconnect the nozzle wires by removing the screw that secures the
ring terminal to the power board.
3. Pull the torch interface cable, from the fan side, through
the upper grommet.
4. Pull the nozzle wires, from the fan side, through the
protective sheathing that passes through the center
panel.
J22
J27
WORK
LEAD
J26
_
RED
J18
ORG
J17
J32
J11
B
R
J28
RED
J17 Socket
Nozzle wire screw
Power board
Upper grommet Torch interface cable
Nozzle wires (2) Protective
sheathing