HEIDENHAIN TNC 620 (73498x-01) ISO programming - Manual (Page 152)

152 Programming: Tools
5.2 T
ool data
Pocket table for tool changer
For automatic tool changing you need the pocket table TOOL_P.TCH.
The pocket table is located in the TNC:\table directory. The machine
manufacturer can adapt the arrangement of the columns and the
content of the pocket table. If you wish, you can select different views
via soft keys in the TABLE FILTER menu. Your machine manual
provides more detailed information.
Editing a pocket table in a Program Run operating mode
U Press the TOOL TABLE soft key to select the tool
table
U To select the pocket table, press the POCKET TABLE
soft key.
U Set the EDIT soft key to ON. On your machine this
might not be necessary or even possible. Refer to
your machine manual.
The machine tool builder adapts the functional range of
the pocket table to the requirements of your machine. The
machine tool manual provides further information.