HEIDENHAIN TNC 620 (73498x-01) ISO programming - Manual (Page 389)

HEIDENHAIN TNC 620 389
14.1 Pr
ogr
amming and ex
ecuting simple mac
h
ining oper
ations
Protecting and erasing programs in $MDI
The $MDI file is generally intended for short programs that are only
needed temporarily. Nevertheless, you can store a program, if
necessary, by proceeding as described below:
Select the Programming and Editing mode of
operation.
To call the file manager, press the PGM MGT key
(program management).
Mark the $MDI file.
To select the file copying function, press the COPY
soft key.
Enter the name under which you want to save the
current contents of the $MDI file.
Copy the file.
To close the file manager, press the END soft key.
For more information: see "Copying a single file", page 101.
DESTINATION FILE =
HOLE