HEIDENHAIN TNC 620 (73498x-01) ISO programming User Manual
Page 26
26
13.1 Switch-on, switch-off ..... 346
13.2 Moving the machine axes ..... 349
Moving the axis using the machine axis direction buttons ..... 349
Incremental jog positioning ..... 350
Traversing with the HR 410 electronic handwheel ..... 351
13.3 Spindle speed S, feed rate F and miscellaneous functions M ..... 352
Changing the spindle speed and feed rate ..... 353
13.4 Datum setting without a 3-D touch probe ..... 354
Workpiece presetting with axis keys ..... 355
Datum management with the preset table ..... 356
13.5 Using 3-D touch probes ..... 362
Selecting touch probe cycles ..... 363
Writing the measured values from touch probe cycles in datum tables ..... 363
Writing the measured values from touch probe cycles in the preset table ..... 364
13.6 Calibrating 3-D touch probes ..... 365
Calibrating the effective length ..... 366
Calibrating the effective radius and compensating center misalignment ..... 367
Displaying calibration values ..... 368
13.7 Compensating workpiece misalignment with 3-D touch probe ..... 369
Measuring a basic rotation ..... 370
Saving a basic rotation in the preset table ..... 370
Displaying a basic rotation ..... 370