Repeating graphic simulation, Displaying the tool, 1 gr aphics – HEIDENHAIN TNC 620 (73498x-01) ISO programming User Manual
Page 399
HEIDENHAIN TNC 620
399
15.1 Gr
aphics
Repeating graphic simulation
A part program can be graphically simulated as often as desired, either
with the complete workpiece or with a detail of it.
Displaying the tool
You can display the tool during simulation in the plan view and in the
projection in 3 planes. The TNC depicts the tool in the diameter
defined in the tool table.
Function
Soft key
Restore workpiece blank to the detail magnification
in which it was last shown.
Reset detail magnification so that the machined
workpiece or workpiece blank is displayed as it was
programmed with BLK FORM.
With the WINDOW BLK FORM soft key, you return the
displayed workpiece blank to its originally programmed
dimensions, even after isolating a detail without
TRANSFER DETAIL.
Function
Soft key
Do not display the tool during simulation
Display the tool during simulation