HEIDENHAIN TNC 620 (73498x-01) ISO programming - Manual (Page 352)

352 Manual operation and setup
13.3 Spindle speed S
, f
eed r
a
te
F and miscellaneous functions M
13.3 Spindle speed S, feed rate F
and miscellaneous functions M
Application
In the Manual Operation and Electronic Handwheel operating modes,
you can enter the spindle speed S, feed rate F and the miscellaneous
functions M with soft keys. The miscellaneous functions are
described in Chapter 7 "Programming: Miscellaneous functions."
Entering values
Spindle speed S, miscellaneous function M
To enter the spindle speed, press the S soft key.
Enter the desired spindle speed and confirm your
entry with the machine START button.
The spindle speed S with the entered rpm is started with a
miscellaneous function M. Proceed in the same way to enter a
miscellaneous function M.
Feed rate F
After entering a feed rate F, you must confirm your entry with the ENT
key instead of the machine START button.
The following is valid for feed rate F:
„ If you enter F=0, then the lowest feed rate from the machine
parameter manualFeed is effective.
„ If the feed rate entered exceeds the value defined in the machine
parameter maxFeed, then the parameter value is effective.
„ F is not lost during a power interruption
The machine tool builder determines which
miscellaneous functions M are available on your control
and what effects they have.
SPINDLE SPEED S =
1000