HEIDENHAIN TNC 620 (73498x-01) ISO programming - Manual (Page 233)

HEIDENHAIN TNC 620 233
8.7 A
d
ditional functions
7 - Tool locked TL
0 = not locked, 1 = locked
8 - Number of the replacement tool RT
9 - Maximum tool age TIME1
10 - Maximum tool age TIME2
11 - Current tool age CUR. TIME
12 - PLC status
13 - Maximum tooth length LCUTS
14 - Maximum plunge angle ANGLE
15 - TT: Number of teeth CUT
16 - TT: Wear tolerance for length LTOL
17 - TT: Wear tolerance for radius RTOL
18 - TT: Direction of rotation DIRECT
0 = positive, –1 = negative
19 - TT: Offset in plane R-OFFS
20 - TT: Offset in length L-OFFS
21 - TT: Break tolerance for length LBREAK
22 - TT: Break tolerance for radius RBREAK
23 - PLC value
24 - Tool type TYPE
0 = milling cutter, 21 = touch probe
27 - Corresponding line in the touch-probe table
32 - Point angle
34 - Lift off
Touch probe cycles, 990 1 - Approach behavior:
0 = standard behavior
1 = effective radius, set-up clearance is zero
2 - 0 = probe monitoring off
1 = probe monitoring on
4 - 0 = stylus not deflected
1 = stylus deflected
Group name, ID no. Number Index Meaning