Yaskawa i80M Appendix - Manual (Page 123)

Check of speed matching axis to 5th axis).
Circle cutting speed in high speed section.
Clearing of program No. when switching on the power.
Code conversion of ISO code during tape input.
Coordinate value when SKIP signal operating (lst axis to 9th axis).
Corner block division.
Correction startup and cancel operation.
Count in parenthesis of TV check.
Cutting feed linear speed constant (X-axis to 5th axis).
Cutting speed bias (X-axis to 5th axis).
Cycle start signal.
Data type of external data input.
Delay time before checking spindle speed attainment signal (SAGR).
Detection of GOO error in solid tap.
Direction of rotation of servo control system motor.
Display lock switch.
‘Drift correction (X-axis).
DRY RUN switch.
Dry run during thread cutting.
Dry run of rapid traverse command.
Dual time of
( E )
Edit, display and output of part program of program numbers 9000 to 9999.
Editing inhibit switch.
EF signal output with G81.
Effective command system (Ist axis to 5th axis).
EOB code with CR during 1S0 code output.
Error allowable range when specifying circular R.
Error cut during emergency stop input (X-axis).
Error detect ON area (X-axis to 5th axis).
Error detect ON area during loop control.
Error detection at end of dwell execution.
Executing stroke check first inhibited area? (X-axis to 5th axis).
Expansion address P or J in work coordinate setting.
External timer display.
#1058 (DO)
#2862
#3005
#3005
#0811
#4013
#4013 (DO)
#0004
#2581
#2821
#5000 (DO)
#5001 (DO)
#1540
#4015
#1030
#oooo
# 0 0 0 0 ( D 2 )
#2000
#2000 (DO)
#4017
#3004 (DO)
#0000
#4016 (DO)
#1004 (DO)
#ooo4
#4820
# 1 0 4 4 ( D 2 )
#1321
#1331
#4015
#6002 (DO)
#4012
#3001 (DO)
– 123 –