Yaskawa i80M Appendix - Manual (Page 254)

9.2 PARAMETER NUMBER TABLE (Cent’d)
Parameter No. N A M E
G54PJ CMPCX3 WSTSGN
(Bit No. 7 6 5 4 3 2 o )
O : Sets “J” as the work coordinate system setting
expansion address.
1 : Sets as the work coordinate system setting
expansion address.
O : Tool radius offset C startup cancel specification I.
1: Tool radius offset C startup cancel specification X3.
O : Inverts incremental input code to work coordinate system
shift amount.
1 : Does not invert incremental input code to work coordi-
nate system shift amount.
O : Becomes valid from the next command when the
amount of work coordinate system shift is changed.
1 : Becomes valid from the next block when the amount of
work coordinate system shift is changed.
– 2 5 4 –