Yaskawa i80M Appendix - Manual (Page 29)

Alarm No. Contents
UNUSABLE G CODE IN CYCLE
#o170 was for a G code unusable in a canned cycle.
G70–G72 USED IN NON CANNED CYCLE
G70–G72 was used in other than a canned cycle.
R–POINT IN BACK BORING
#0172 Returns to R–point in G77 (back boring
G73/G83 ERROR O)
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ---------
There is no command for Qor I or the command was for
in the s t a t e .
G70–G72 ADDRESS ERROR
. . . . . . . . . . . . . . . . -------------- --------------- --------------- -------
Specified address for command G70, G71, or G72 is invalid.
#01 76
#0178
#o179
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .