Yaskawa i80M Appendix User Manual
Page 135
Parameter No.
N A M E
#ooo7
BUZON
PRMOOUT
TLCNTE
SK IPON
UMSBK
(Bit No.
7
6
5
4
3
2
1
o
)
O : Does not emit sound from operator panel buzzer.
1: Emits sound from operator panel buzzer.
O : Outputs data O when outputting parameters.
1 : Outputs data O when outputting parameters.
O : Data not displayed on screen at tape 1/0 collation.
1: Data displayed on screen at tape 1/0 collation.
O : Life management executed at T command.
1: Life management not executed at T command.
O : Work coordinate shift correction amount not added.
1: Work coordinate shift correction amount added.
O : Alarm occurs if skip signal does not go ON until end
of skip function block movement.
1:
Alarm if skip signal does not go ON until end of
skip function block movement.
O : Operation command and control command in the user
macro program do not stop in a single block.
1:
operation command and control command
in the user
macro program stop in a single block .
O : Changes input unit to millimeters.
1: Changes input unit to inches.
Reset is required.
–
1 3 5
–