Yaskawa i80M Appendix - Manual (Page 13)

Alarm No. Contents
THERROR (TP)
TH parity error during tape operation.
TV ERROR
#ool 1 TV parity error during tape operation.
ILLEGAL CHARACTER (TP)
There are unusable characters other than code with
during tape operation.
1 BLOCK LENGTH ERROR
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
One block over capacity (128 characters) was detected during tape
operation 1.
DATA SET READY DOWN
. .
Data set ready signal is not response in tape operation.
NUMERIC DATA OVERFLOW
Input data digits overflow in tape operation (Beyond 9 characters).
RS – 232C ERROR (CH SELECT)
#0016 RS–232C interface transmission abnormal.
Parity error occurs.
ERROR (OVER RUN)
RS–232C interface overrun error.
(Improper protocol setting or transmission error).
RS – 232C ERROR (CH SELECT)
. . . . . .
#0018 Error in selection of RS–232C interface circuit.
RS–232C ERROR (FRAMING)
interface framing error.
(Improper stop-bit setting or transmission error).