Yaskawa i80M Appendix - Manual (Page 266)

9.2 PARAMETER NUMBER TABLE (Cent’d)
Parameter No.
EIA code punch pattern #
EIA code punch pattern [ I
code punch pattern ]
EIA code punch pattern *
EIA code punch pattern = I
code punch pattern (
EIA code punch pattern )
m
EIA code punch pattern ,
EIA punch pattern ‘
EIA oode punch pattern
Hole special character EIAused inuser macro.
Setting: Considers hole pattern in binary andconverts thisto
decimal value.
Tool life management group command T-number offset.
Setting : T command
x 1000 = tool life management
group
Example : When 1 is set for #4110, TIOO1 to are used as tool
life management T commands.
Setting range : 0 to 9
– 2 6 6 –