Yaskawa i80M Appendix - Manual (Page 257)

Parameter No. N A M E
#4016 CANTP2
I
(Bit No. 7 6 5 4 3 2 1
O : Reverses spindle without outputting M05 at the bottom
of the hole in canned cycles G74 and G84.
1: Reverses spindle by outputting M05 at the bottom of the
. hole in canned cycles G74 and G84.
O : Sets M output in canned cycles G74 and G84 as inversion
of M code prior to the canned cycle.
1: Sets M output in canned cycles G74 and G84 as G74 : M03
and G84 : M04.
O : Sets GOO as the positioning operation of the canned
1: Sets positioning operation of the canned cycle to the
currently selected 01 group code (GOO or ).
– 2 5 7 –