Yaskawa i80M Appendix User Manual
Page 204
9.2 PARAMETER NUMBER TABLE (Cent’d)
Parameter No.
N A M E
ROTJOG
FOVAB
PRDOV
SCRDRN RPDDRN
(Bit No.
7
6
5
4
3
2
1
1 :
1 :
1 :
Jog speed of rotating shaft is not made 1/10 of linear
axis.
Jog speed of rotating shaft is made 1/10 of linear axis.
Uses rapid feed until completion of reference point
return after powr is switched on.
Uses jog until completion of reference point return after
power is switched on.
Feed override signal is valid at “ 1” (NC contact).
Feed override signal is valid at “O” (NC contact).
Sets rapid feed override to the 4 steps of FO, 25, 50 and
100% .
Sets rapid feed override to the 6 steps of FO, Fl, F2, 25,
50, 100%.
Dry run is valid during tapping.
Dry run is invalid during tapping.
Makes dry run invalid in rapid feed command.
Makes dry run valid in rapid feed command.
– 2 0 4 –