Yaskawa i80M Appendix User Manual
Page 49
Alarm No.
Contents
#0390
PROGRAM O NUMBER NOT FOUND
. . .
Program to be executed was not found.
PROGRAM BEING READ
#0391
Program to be executed was being loaded.
#0392
#0393
PROGRAM BEING EDITED
Program to be executed was being edited.
SEQUENCE NUMBER NOT FOUND
. . . .
Specified sequence number was neither
command or G25.
#0394
#0395
IMPOSSIBLE REQUEST DURING MEM/TAPE OPERAT 10N
Change to memory/tape mode and cycle start was requested in
tape/memory mode.
#0396
CANNOT RETURNIN TAPE/DIRECT
An attempt to return to the main program was made by program
interruption during TAPE/DIRECT operation.
INTERRUPT ACTION (TAPE/DIRECT)
l----------------------- .---------------- .------------ .--------
#0397
I
Interference was made so that re–execution would be impossible.
#0398
#0399