Yaskawa i80M Appendix - Manual (Page 128)

9.1 PARAMETER NUMBER LIST (Cent’d)
S code macro call specification (1 to 24)
S output symbol
Saving of D code when resetting.
Saving of H code during reference point return when resetting.
Scaling multiplying factor setting (numerator).
Scaling multiplying factor setting (denominator).
Segment type of high speed mode operation.
Sequence number setting of break point.
Servo control system linear axis/rotating axis (X-axis).
Servo control system servo control (X-axis).
Servo power ON.
Servo spindle No. for solid tap.
Shift angle during G76 and G77 commands.
Shift speed of canned cycle G76 and G77.
Significant number of systems.
Single block in a user macro program.
Single block switch.
SKIP signal ON.
SKIP signal polarity.
SKIP signal valid/invalid.
Slot spindle information to 6th).
Solid tap return speed multiplying factor.
Solid tap servo axis interrupt in-position width.
Solid tap synchronization correction parameter.
Specified section end code of operating mode of high speed mode operation.
Specified section start code of operating mode of high speed mode operation.
Speed during skip operation.
Speed in relation to cutting feed of external deceleration.
Spindle display name.
Spindle feed back pulse multiple setting.
Spindle gear range maximum rotations.
Spindle gear range minimum rotation clamp.
Spindle gear range motor maximum rotation clamp.
Spindle indexing confirmation timer.
Spindle indexing creep speed.
Spindle indexing during loop control.
Spindle indexing start speed.
Spindle indexing stop confirmation rotations.
#4888
#1001 (DO)
#4010
#4010
#0803
#0804
#4167
#0801
(D6)
#1030
#5012 (DO)
#1241
#0805
#2864
#1318
#0007
#0000 (DO)
#0007
#5011 (DO)
#5010 (DO)
#1020 (DO)
#1252
#1500
#1502
#4164
#4161
#2440
#2445
#1127
#1404
#1400
#1408
#1220
#2546
#1053
#2541
#1225
– 128 –