Yaskawa i80M Appendix - Manual (Page 189)

Parameter No. N A M E
m
Number of teeth of the spindle intermediate gear of gear A used for
spindle loop control during solid tap.
Setting : 1 = 1 tooth
Setting range : 0 to 32767
Number of teeth on the motor side if there is no intermediate
gear.
Number of teeth of the intermediate gear of gear A used for spindle
loop control during solid tap.
Setting : 1 = tooth
Setting range : 0
32767
be O when there is no intermediate gear.
Number of teeth on the motor side gear A used for spindle loop
control during solid tap.
Setting : 1 = tooth
Setting range : 0 to 32767
Will be O when there is no intermediate gear.
Number of teeth of gear B on the spindle side for spindle loop control
during solid tap.
Setting,: 1=1 tooth
Setting range :0 to 32767
Number of teeth of the spindle intermediate gear of gear B used for
spindle loop control during solid tap.
Setting : 1=1 tooth
Setting range :0 to 32767
Number teeth on the motor side if there is no intermediate gear.
Number of teeth of the intermediate gear of gear B used for spindle loop.
control during solid tap.
Setting : 1=1 tooth
Setting range :0 to 32767
Will be O when there is no intermediate gear.
– 1 8 9 –