Yaskawa i80M Appendix - Manual (Page 124)

9.1 PARAMETER NUMBER LIST (Cent’d)
[ F )
digit speed(Fl to F9).
digit switch.
Feed during tape output.
Feed override signal (Point A).
Feedrate (O to 31 to the JOG feedrate selection switch position
Feedrate during skip function.
Feedrate during skip function.
Feedrate filter time constant (X-axis to 5th axis).
First step of rapid traverse speed time constant.
(X-axis to 5th axis).
processing in servo OFF input (X-axis).
Form correction coefficient (01 to 09, 11 to 19).
F speed unit setting with 1/10.
( G ]
G code default value (When switching on power or resetting).
G code (1 to 24) macro call.
G45 to G48 correction No. command code.
G60 unidirectional positioning direction (X-axis to 5th axis).
G76/G77 dwell time.
Gear No. for spindle loop control.
[ H ]
Handle multiplying factor X 100 selection multiplying factor.
Handle speed constant (X-axis to 5th axis).
High speed/low speed changeover of automatic reference point return.
High speed automatic start in high speed rewind.
High speed mode operation address name (4th axis to 5th axis).
Hole pattern of EIA code used in user macro.
In-position wait with the GOO and GO1 GOO command.
Input device specification.
Input port specification.
Input unit mm/inch.
Intermediate pot display.
Internal M code of initial state (When switching on power or resetting).
Internal system number switch setting.
Internal toggle switch.
Interruption check function (radius compensation).
Is alarm to be set when executing move command other than G28 without
conducting reference point return ?
Is alarm to be set when cycle starts without reference point return?
Is change of amount of work coordinate shift to be immediately valid?
#0820
#ooo5
# 0 0 0 4 ( D 4 )
#2000
#2400
#2001 (DO)
#2001
#2591
#2461
#1044
#1801
#2004 (DO)
#4000 (DO)
#4480
#4011
#4014 (DO)
#0400
#1260
#2003
#2561
#4003
#4008
#1201
#4100
# 4 0 1 5 ( D 4 )
#0010 (DO)
#0009 (DO)
#0007 (DO)
#3001
#4001 (DO)
#5001
#4013
#4004 (DO)
#4001
#4012 (DO)
– 1 2 4 –