Application example – Yaskawa MotionWorks IEC Toolboxes User Manual
Page 112
Cam Toolbox: Function Blocks
MotionWorks IEC61131-3 Toolboxes: 2013-09-13
99
Application Example
This example illustrates how the CamControl block can be applied in a linear flying shear application. In this
application, the items to be cut are defective areas (knots) in a piece of wood. The code shown here performs
the following actions:
1.
stores the position of each defect where a cut must be made.
2.
synchronizes the master (conveyor moving the wood) and slave (saw).
3.
The CamControl.Engage output must be connected to Y_CamIn.Execute. (Other logic requirements
may be included if necessary.)
4.
Key Point: When defects are close together, the goal is to remain engaged, and use the CamShift
function during the slave (saw) retraction stroke while not in contact with the wood to re-synchronize
with the next defect (or knot) to be cut.
5.
The CamControl.Disengage output must be connected to Y_CamOutExecute. In this application, it will
cause the slave (saw) to disengage when the ProductBuffer indicates that there are no more defects to
be cut.