Yaskawa Large Capacity Sigma II Series - Manual (Page 262)

6 Using the Digital Operator
6.2.9 Initializing Parameter Settings
6-42
6.2.9 Initializing Parameter Settings
This function is used when returning to the standard settings (factory settings) after changing
parameter settings.
Initialize the parameter settings with the servo OFF.
Follow the procedure below to initialize parameter settings.
Using the Hand-held Digital Operator
1. Press the DSPL/SET Key to select the auxiliary function mode.
2. Select the parameter Fn005. Press the Left or Right Cursor Key to select the digit. Press
the Up or Down Cursor Key to change the number.
3. Press the DATA/ENTER Key. The following display will appear.
4. Press the DSPL/SET Key and the display will change as shown below. The parameter
will be initialized.
5. Press the DATA/ENTER Key to return to the auxiliary function mode display.
This completes the initialization of parameter settings.
IMPORTANT
Flashing for
one second
Flashing during
Initialization
End