Areca ARC-8050T3U 6-Bay Thunder3 Desktop RAID Storage Array - Manual (Page 89)

89
WEB BROWSER-BASED CONFIGURATION
Clone Disk Procedure
1. Select one of the members as the “Clone Source” (status indi-
cated as Raid Set #) by clicking on the appropriate check box.
2. Select a “Clone Target” (status indicated as Free or Hot Spare)
by clicking on the appropriate check box.
3. If you have available disk member, you can repeat above pro
cedures to define another clone pair.
4. Select Clone Type.
The pair number for both the “Clone Source” and the “Clone
Target” will be indicated in the screen. Tick on the “Confirm The
Operation” check box and click on the “Submit” button on the
screen; the controller will automatically start the cloning process
using the existing “stand-by” (Free or Hot Spare drive) to clone
the source drive (the Raid Set member drive). The cloning pro-
cess percentage will be indicated in the “Volume State” area of
the “Volume Set Information” screen. Completion of the Clone
function process will be indicated by a notification message on the
event log.
4.8.4.1 Clone And Replace
You can enlarge your logical drives by copying and replacing all
member drives with drives of higher capacity. The existing data
in the logical drives is copied onto the new drives, and then the
original members are marked as “Offlined”.
4.8.4.2 Clone Only
The stand-by disk will clone the logical drives without substitut-
ing it. The status of the stand-by drive will be marked as “Of-
flined” after the cloning process. The source drive will remain a
member of the logical drive.