Cpu core fault register bit definitions -3 – Intel PXA255 User Manual
Page 33
Intel® PXA255 Processor Developer’s Manual
2-3
System Architecture
2.2.2
Coprocessor 14 Registers 0-3 - Performance Monitoring
The processor does not define any performance monitoring features beyond those called out in the
Intel® XScale™ Microarchitecture for the Intel® PXA255 Processor User’s Manual, order number
278793. The interrupt generated by performance monitoring events is defined in
Chapter 4,
“System Integration Unit”
. The ASSP defined performance monitoring events (events 0x10 -
0x17), defined through the PMNC register are reserved for the processor.
2.2.3
Coprocessor 14 Register 6 and 7- Clock and Power
Management
These registers allow software to use the clocking and power management modes. The valid
operations are described in
Table 3-23, “Coprocessor 14 Clock and Power Management Summary”
on page 3-39
.
2.2.4
Coprocessor 15 Register 0 - ID Register Definition
This register may be read by software to determine the device type and revision. The contents of
this register for the Intel® PXA255 Processor is defined in the table below. Combined, this register
must read as 0x6905 2X0R where R = 0b0000 for the first stepping and then increments for
subsequent steppings, and X is the revision of the Intel® XScale™ microarchitecture present.
Please see the Intel Developer Homepage at http://developer.intel.com for updates.
This is a read-only register.
Table 2-1. CPU Core Fault Register Bit Definitions
Coprocessor 7
Register 4
CPU Core Fault
System Architecture
Bit
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10 9
8
7
6
5
4
3
2
1
0
Re
s
e
rv
e
d
PS
F
S
Re
s
e
rv
e
d
Reset
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
[31:6]
—
Reserved.
Read undefined.
5
PSFS
Power Source Fault Status
0 = nVDD_FAULT or nBATT_FAULT pin has not been asserted since it was
last cleared by a reset or the CPU.
1 = nVDD_FAULT or nBATT_FAULT pin was asserted and PMCR[IDAE] =
1.
Read only, write ignored.
Cleared by Hardware, Watchdog, and GPIO Resets.
[4:0]
—
Reserved.
Read undefined.