Physio-Control LIFEPAK 20e - Manual (Page 147)

8
S
etu
p
Opti
ons
Setup Options
LIFEPAK 20e Defibrillator/Monitor Operating Instructions 8-11
©2006-2013 Physio-Control, Inc.
ALARMS SETUP MENU
The Alarms Setup menu allows you to define alarms and set the alarm volume level. When you
select a menu item, the screen displays a help message. The underlined options are factory
default settings.
PRINTER SETUP MENU
The Printer Setup menu allows you to define automatic event printing and ECG frequency
response. When you select a menu item, the screen displays a help message. The underlined
options are factory default settings.
Table 8-15 Alarms Setup Menu
Menu Item Help Message Options
VOLUME Set volume for alarms, tones,
and voice prompts Select volume level from gradient display.
The minimum setting reduces but does not
silence alarms.
ALARMS Enable alarms at power up ON : Enables alarms for Heart Rate, SpO
2
,
and CO
2
whenever defibrillator power is
turned on.
OFF : Alarms available through ALARMS
button.
VF/VT ALARM Alarms when VF or VT
detected ON : Enables VF/VT alarm whenever
defibrillator power is turned on.
OFF : VF/VT alarm available through
ALARMS button.
Table 8-16 Printer Setup Menu
Menu Item Help Message Options
AUTO PRINT Specify Auto Print Event Refer to Table 8-17 .
ECG MODE Default ECG frequency
response MONITOR or DIAGNOSTIC
MONITOR MODE Default monitor frequency
response for printer and
display 1–30 HZ or .5–40 HZ .
DIAGNOSTIC MODE Default diagnostic frequency
response for printer .05–40 HZ or .05–150 HZ .
ALARM EVENTS Print waveforms with alarm
events and print with
CODE SUMMARY report ON or OFF .
EVENT
WAVEFORMS Print waveforms with user-
entered events and print with
CODE SUMMARY report ON or OFF .