Physio-Control LIFEPAK 20e - Manual (Page 203)

Docking Station
LIFEPAK 20e Defibrillator/Monitor Operating Instructions G-1
©2006-2013 Physio-Control, Inc.
Appendix G
LIFEPAK 20E DEFIBRILLATOR/MONITOR DOCKING STATION
The LIFEPAK 20e defibrillator/monitor docking station allows you to secure your defibrillator to
an emergency cart or other flat surface. The docking station provides a 360-degree turning
radius for the viewing of the LIFEPAK 20e defibrillator/monitor display from any angle.
Note: The docking station cannot be used with the CodeManagement Module.
To insert the LIFEPAK 20e defibrillator/monitor into the docking station:
1 Hold the LIFEPAK 20e defibrillator/monitor by the handle over the docking station (refer to
Figure G-1 , arrow 1).
2 Tilt the LIFEPAK 20e defibrillator/monitor backward into the docking station, aligning slots in
the rear of the defibrillator to rollers on the docking station (refer to Figure G-1 , arrow 2).
3 Align recess in lower front panel of the LIFEPAK 20e defibrillator/monitor with the front roller
on the docking station and press down on the front of the LIFEPAK 20e defibrillator/monitor
until you hear a click (refer to
Figure G-1 , arrow 3).
4 Check to make sure that the LIFEPAK 20e defibrillator/monitor is securely locked into
position.
To turn the LIFEPAK 20e defibrillator/monitor while in the docking station:
1 Grasp the LIFEPAK 20e defibrillator/monitor by the handle, or by its sides.
2 Turn to the correct position. You will hear clicking sounds as the defibrillator locks into place.
Figure G-1 Docking Station
To remove the LIFEPAK 20e defibrillator/monitor from the docking station:
1 Grasp the LIFEPAK 20e defibrillator/monitor by the handle.
2 Pull briskly on the LIFEPAK 20e defibrillator/monitor until it releases from the docking station.
Note: To install the docking station to a flat surface or wall mount (GCX) bracket, refer to the
docking station installation instructions or consult the LIFEPAK 20e Defibrillator/Monitor
Service Manual.
3
2 1