Physio-Control LIFEPAK 20e - Manual (Page 183)

Appen
d
ix C
Screen Messages
LIFEPAK 20e Defibrillator/Monitor Operating Instructions C-5
©2006-2013 Physio-Control, Inc.
STAND CLEAR/PUSH
SHOCK BUTTON Stand clear of the patient and push the SHOCK button.
START CPR Initiate CPR in AED mode.
SWITCHING PRIMARY
TO LEAD II PADDLES lead is not available and you pressed the ANALYZE button.
SWITCHING PRIMARY
TO PADDLES PADDLES lead is available and you pressed the ANALYZE button.
TRANSMISSION
CANCELLED Data transmission has been cancelled.
TRANSMISSION
COMPLETE Data transmission completed successfully.
TRANSMISSION
FAILED Data transmission was not successful.
UNABLE TO TRANSMIT Unable to send data.
USE ECG LEADS The device is attempting synchronized cardioversion and PADDLES
lead was selected.
USER TEST DID NOT
COMPLETE Test plug not connected to QUIK-COMBO therapy cable, standard
paddles not seated in paddle wells, possible defective therapy cable,
or a problem with the defibrillator during user test.
USER TEST DID NOT
COMPLETE –
CONNECT TO TEST
PLUG Test plug not connected to QUIK-COMBO therapy cable, standard
paddles not seated in paddle wells, defective therapy cable, or a
problem with the defibrillator during user test.
USER TEST FAILED An unsuccessful user test has occurred.
USER TEST IN
PROGRESS Confirms that the user test is in progress.
USER TEST
SUCCEEDED A successful user test was completed.
XX% TRANSMITTED Specified percent of the transmission is completed.
Table C-1 Summary of Screen Messages (Continued)
Message Description