Physio-Control LIFEPAK 20e - Manual (Page 182)

Screen Messages
C-4 LIFEPAK 20e Defibrillator/Monitor Operating Instructions
PUSH PADDLE
BUTTONS TO SHOCK! If standard paddles are attached, the front panel SHOCK button is
disabled. Message appears if you attempt to transfer energy by
pressing the front panel
SHOCK button.
PUSH SHOCK
BUTTON! The defibrillator is fully charged and ready to provide therapy (a
therapy cable or internal paddles must be connected).
PUSH SPEED DIAL TO
DISARM An instruction on the charging screen overlays for disarming the
charge.
RA LEADS OFF
R LEADS OFF
ECG electrode RA is disconnected.
ECG electrode R is disconnected.
RL LEADS OFF
N LEADS OFF
ECG electrode RL is disconnected.
ECG electrode N is disconnected.
REMOVE TEST PLUG The QUIK-COMBO test plug is connected to the QUIK-COMBO
therapy cable.
SEARCHING FOR
SIGNAL Remote sync is selected and the device is qualifying the input signal.
SELF TEST DID NOT
COMPLETE Test plug not connected to QUIK-COMBO therapy cable, standard
paddles not seated in paddle wells, possible defective therapy cable,
or a problem with the defibrillator during daily auto test.
SELF TEST DID NOT
COMPLETE –
CONNECT TO TEST
PLUG Test plug not connected to QUIK-COMBO therapy cable, standard
paddles not seated in paddle wells, possible defective therapy cable,
or a problem with the defibrillator during daily auto test.
SELF TEST FAILED An unsuccessful self test has occurred.
SELF TEST IN
PROGRESS Confirms that the self test is in progress.
SELF TEST
SUCCEEDED A successful self test was completed.
SHOCK ADVISED! The defibrillator detected a shockable rhythm.
SPO2: CHECK
SENSOR The SpO
2
sensor detached from the patient after a measurement was
obtained.
SPO2: LOW
PERFUSION Patient has a weak pulse.
SPO2: NO SENSOR
DETECTED A sensor was disconnected from the monitor.
SPO2: SEARCHING
FOR PULSE Confirms the pulse oximetry sensor is connected to the defibrillator.
SPO2: UNKNOWN
SENSOR A sensor is connected to the device that is not compatible with the
Masimo SpO
2
module.
Table C-1 Summary of Screen Messages (Continued)
Message Description