ADC CUDA 3 - Manual (Page 125)

Cuda 12000 IP Access Switch CLI-based Administration Guide
Packet Over SONET (POS) Interface Administration 123
Clearing Interface Counters
You can clear interface counters for a selected POS interface. To do so,
perform the following task within interface pos <c/s/i> mode:
Disabling and Enabling Interfaces
You can manually take an interface offline or bring it online. When an
interface is enabled (online), it can forward traffic; when disabled (offline) it
cannot.
NOTE: Enabling a POS interface assumes the POS interface is already
configured.
To disable and enable a POS interface, perform the following tasks in
interface pos <c/s/i> mode:
In this example, the user disables the POS interface in slot 3 and then brings
it back online:
cli:172.16.19.10:root# interface 1/3/1
mode: interface:pos:csi(1/3/1)
cli:172.16.19.10:interface:pos:csi(1/3/1)# shutdown
cli:172.16.19.10:interface:pos:csi(1/3/1)# no shutdown
Loopback Indicates loopback configuration.
Last clearing of counters Time (SysUpTime) since the counters were
last cleared and reset to zero.
PPP Authentication Security Mode Indicates authentication used on this
interface — PAP or CHAP
Task Command
Clear all counters for the current POS
interface. clear counters
Display Element Description
Task Command
1. Disable the POS interface so that
the administrative status is down.
shutdown
2. Enable the POS interface so that the
administrative status is up.
no shutdown