ADC CUDA 3 - Manual (Page 311)

Cuda 12000 IP Access Switch CLI-based Administration Guide
Configuring OSPF 309
4. Configure the interface priority. This
number identifies the priority of the
Cuda 12000 relative to other OSPF
routers on the current interface. The
number is used to elect the
designated and backup designated
routers. The router with the highest
priority is considered the designated
router.
A value of 0 indicates that the router
is not eligible to be the designated or
backup designated router. If all
routers have the same priority, the
router ID is used to determine the
designated router.
When OSPF is initially enabled on the
interface, the priority defaults to 5.
ip ospf priority <number>
5. Configure the retransmit interval, in
seconds. When OSPF is initially
enabled on the interface, the
retransmit interval defaults to 5
seconds.
While it is common practice to
configure all OSPF neighbors with the
same retransmit interval value, it is
not required.
ip ospf retransmit-interval <seconds>
6. Configure the transit-delay, in
seconds. When OSPF is initially
enabled on the interface, the transit
delay defaults to 1 second.
While it is common practice to
configure all OSPF neighbors with the
same transit delay value, it is not
required.
ip ospf transit-delay <seconds>
Task Command