ADC CUDA 3 - Manual (Page 407)

Cuda 12000 IP Access Switch CLI-based Administration Guide
Configuring Upstream Channels 405
CM Range Invite Timeout (millisec)
This is the minimum time allowed for a cable modem following receipt of a
RNG-RSP, before it is expected to reply to an invitation to range request in
milliseconds. By default, the CM Range Invite Timeout is set at 400
milliseconds.
You set the CM range invite timeout for an upstream channel by performing
the following tasks.
.
Maximum Power Adjustment (1/4 dB)
The maximum adjustment permitted on a single Range Response message,
specified in 1/4 dB units. By default, Maximum Power Adjustment is set at 6
dB.
You set the maximum power adjustment for an upstream channel by
performing the following tasks.
.
Task Command
1. Enable interface cable mode. interface cable <c/s/i>
2. Set CM range invite timeout. upstream <port number> ranging
init-range-timeout <0..65535>
Task Command
1. Enable interface cable mode. interface cable <c/s/i>
2. Set maximum power adjustment. upstream <port number> ranging
max-power-adjust <0..255>