Downstream modulation – ADC CUDA 3 User Manual
Page 387
Advertising
Cuda 12000 IP Access Switch CLI-based Administration Guide
Configuring the Downstream Channel
385
Downstream Modulation
The Downstream modulation parameter sets the modulation rate for a
downstream channel. The CMTS supports the following two modulation
types.
You set the downstream modulation type by performing the following tasks.
Task
Command
1. Enter interface configuration
mode.
interface cable <c/s/i>
2. Configure modulation used on
the downstream channel. Valid
values:
■
qam64: Set
s the interface speed
at 30 Mbps
or
■
qam256:
Sets the interface
speed at 40 Mbps
downstream modulation
{qam64 | qam256}
Advertising