ADC CUDA 3 - Manual (Page 403)

Cuda 12000 IP Access Switch CLI-based Administration Guide
Configuring Upstream Channels 401
Upstream Channel MAP Configuration
You can fine tune MAP generation for upstream channels, as described in
the following sections.
Initial Maint Region Size (microsec)
The size of the upstream channel Initial Maintenance (IM) contention region.
Maps with Initial Maint regions are sent periodically. By default, Initial Maint
Contention Region Size is set at 500.
You set the initial maintenance contention for an upstream channel by
performing the following tasks.
.
Task Command
1. Enable interface cable mode. interface cable <c/s/i>
2. Configure the initial maintenance
size for an upstream channel.
upstream <port number> map
init-maint-contention-size
<0..65535>