ADC CUDA 3 - Manual (Page 515)

Cuda 12000 IP Access Switch CLI-based Administration Guide
Configuring CPE Control Parameters 513
To set chassis-wide Subscriber Management defaults for CPE devices,
perform the following tasks:
Task Command
1. Enter cable interface mode. interface cable <c/s/i>
2. From any mode, specify that
you do not want to disable
Subscriber Management on
all cable interfaces on the
chassis.
no cpe-control active
3. From any mode, specify that
you want to enable
Subscriber Management on
all cable interfaces on the
chassis.
cpe-control active
4. From any mode, specify the
maximum number of IP
addresses available to CPE
devices on all cable interfaces
on the chassis.
cpe-control max-ip <0..16>
5. From any mode, remove the
maximum number of IP
addresses available to CPE
devices on all cable interfaces
on the chassis.
no cpe-control max-ip
6. From any mode, specify that
you want the CMTS to learn
all IP addresses of CPE
devices on all interfaces on
the chassis.
cpe-control learnable
7. From any mode, specify that
you do not want the CMTS
to learn all IP addresses of
CPE devices on all interfaces
on the chassis.
no cpe-control learnable
8. From any mode, display the
chassis-wide defaults for
Subscriber Management CPE
control.
show cpe-control