ADC CUDA 3 - Manual (Page 57)

Cuda 12000 IP Access Switch CLI-based Administration Guide
Command Modes 55
Import and Export RIP Route Filter Modes
Route filters control the flow of routes to and from the routing table. Import
route filters control which routes are stored in the routing table. Export filters
control which routes are advertised to other routers. You can define route
filters to control the flow of both OSPF and RIP routes.
To create RIP import route filters, enter import mode from within router:rip
mode or type router rip import from within any mode. You can then use
the available commands to create route filters to control which RIP routes the
system learns.
To create RIP export route filters, enter export mode from within router rip
mode or type router rip export from within any mode. You can then use
the available commands to create route filters to control which RIP networks
the router advertises to other RIP-enabled routers.
Table 2-8 lists available RIP import and export route filter commands as they
appear when you type help at the command prompt. CLI global commands
are not listed and can be found in Table 2-1 on page 42. Note that the help
command output displays many commands in their abbreviated form.
Table 2-8 RIP Import and Export Route Filter Mode Commands
Command Description
map-list Adds a route map to a map list.
match Specifies criteria that is matched against route entries.
override Configures the override values for import or export
filters.
route-map Creates a route map.