ADC CUDA 3 - Manual (Page 497)

Cuda 12000 IP Access Switch CLI-based Administration Guide
About CPE Control 495
About CPE Control
In addition to providing added security through filtering, Subscriber
Management provides added security by limiting the number of IP addresses
available to CPE devices, which minimizes the risk of malicious tampering
against your cable network.
Subscriber Management allows a maximum of 16 IP addresses available to
CPE devices. Once the limit that you configure is met, packets from
additional IP addresses are dropped.
You can:
■
Specify a default set of CPE control parameters that apply chassis-wide.
■
Configure CPE control parameters on a modem-by-modem basis. When
you configure parameters on a modem-by-modem basis, you send SNMP
sets directly to the cable modem. These changes do not persist.