ADC CUDA 3 - Manual (Page 427)

Cuda 12000 IP Access Switch CLI-based Administration Guide
Defining Modulation Profiles 425
cli# modulation-profile 3 interval-usage short diff
cli# modulation-profile 3 interval-usage short seed 38
cli# modulation-profile 3 interval-usage short pre-len 8
cli# modulation-profile 3 interval-usage short last-cw fixed
cli# modulation-profile 3 interval-usage long fec-tbytes 6
cli# modulation-profile 3 interval-usage long fec-len 8
cli# modulation-profile 3 interval-usage long burst-len 120
cli# modulation-profile 3 interval-usage long mod qpsk
cli# modulation-profile 3 interval-usage long no scrambler
cli# modulation-profile 3 interval-usage long diff
cli# modulation-profile 3 interval-usage long seed 38
cli# modulation-profile 3 interval-usage long pre-len 8
cli# modulation-profile 3 interval-usage long last-cw fixed
You can then verify the new modulation profile using the show cable
interface <c/s/i> modulation-profile <profile number> command from
within either root or cable interface mode, or the show modulation-profile
<profile number> command from within cable interface mode.
Displaying Modulation Profiles
You display the modulation profiles currently configured on a cable interface
by performing one of following tasks:
.
Task Command
1. Enter this command within root
mode or cable interface
configuration mode to display all
modulation profiles on the
specified cable interface.
show interface cable <c/s/i>
modulation-profile
2. Enter this command within cable
interface configuration mode to
display all modulation profiles on
the specified cable interface.
show modulation-profile