ADC CUDA 3 - Manual (Page 280)

ADC Telecommunications, Inc.
278 C HAPTER 14: C ONFIGURING IP
Configuring Static Routes
You can manually add static routes to the Cuda 12000 routing table. Static
routes take precedence over dynamically-learned routes to the same
destination. These routes are useful in network environments where no
routing protocol is used, or to override select routes discovered using a
routing protocol.
Configuring static routes consists of the following tasks:
■
Adding Static Routes
■
Deleting Static Routes
■
Adding the Default Route
■
Deleting the Default Route
Adding Static Routes
To add a static route, configure the following parameters:
Table 14-1 Static Route Parameters
Parameter Description
Destination IP address of the destination network,
subnetwork or host.
Network Mask Network Mask assigned to the destination IP
address.
Gateway IP address of the next hop (gateway) used to
reach the destination.
Metric Assigns a metric to this static route. The metric
is a number that is used to select the route
when multiple routes to the same destination
exist. The route with the lowest metric is
selected. The default is 1.