ADC CUDA 3 - Manual (Page 157)

Cuda 12000 IP Access Switch CLI-based Administration Guide
Configuring Fault Reporting 155
Removing a Fault Notification
In the event that you no longer wish to be notified of a fault condition, you
may remove a specified fault notification by performing the following tasks:
Task Command
1. Enter root mode. root
2. Remove the fault condition
from the notification report.
no chassis-fault {backplane |
backplane-power |
backplane-power-a |
backplane-power-b |
backplane-temp |
bits-a |
bits-b |
blue |
fan-rotation |
fan-temp |
local-pwr-a |
local-pwr-b |
processor-temp |
ps-ac |
ps-dc |
ps-temp |
red-alarm |
yellow}