ADC CUDA 3 - Manual (Page 397)

Cuda 12000 IP Access Switch CLI-based Administration Guide
Configuring Upstream Channels 395
You set the upstream slot size by performing the following tasks.
Receive Power
The Receive Power parameter sets the level for the upstream interface in
TenthdBmV. By default, the Receive Power is set at 0, which is the optimal
setting for the upstream power level. Acceptable values are -160 to 260
TenthdBmV. The Receive Power is dependent on the selected channel-width.
You set the upstream receive power by performing the following tasks.
Task Command
1. Enter interface cable mode. interface cable <c/s/i>
2. Set the upstream channel
mini-slot size.
upstream <port number>
minislot-size
{2 | 4 | 8 | 16 | 32 | 64 | 128}
Task Command
1. Enter interface cable mode. interface cable <c/s/i>
2. Set the upstream receive power
level.
upstream <port number>
power-level <-160..260>