ADC CUDA 3 - Manual (Page 549)

Cuda 12000 IP Access Switch CLI-based Administration Guide
Cable Modem and MTA Command Output Descriptions 547
Table 21-15 systemGroup Parameters
Table 21-16 docsDevBase, docsDevSoftware, and docsDevServer Parameters
docsBpi2CmTEKInvalidError
String Display string in the most recent TEK invalid
message received by the cable modem. If no TEK
invalid message has been received since reboot,
this value displays as a zero length string.
CLI Output Description
Descriptor Provides a textual description of the cable modem vendor.
Contact A contact person for the network.
Name The name of the network device.
Location Location of the network device.
CLI Output Description
Serial Number Manufacturer's serial number for this device.
STP Control Controls operation of the spanning tree protocol (as
distinguished from transparent bridging). Values are:
stEnabled Spanning tree protocol is enabled, subject to bridging
constraints.
noStFilter
Bpdu Spanning tree is not active, and Bridge PDUs received are
discarded.
noStPass
Bpdu Spanning tree is not active and Bridge PDUs are transparently
forwarded.
SW Server IP address of the TFTP server used for software upgrades. If
the TFTP server is unknown, 0.0.0.0 is displayed.
SW Filename Filename of the software image to be loaded into this device.
Unless set via SNMP, this is the file name specified by the
provisioning server that corresponds to the software version
that is desired for this device. If the filename is unknown, the
string “unknown” is returned.
Admin Status Current provisioning administrative status. Values include:
CLI Output Description