Configuring downstream parameters, Annex type, Downstream shutdown – ADC CUDA 3 User Manual
Page 384
ADC Telecommunications, Inc.
382
C
HAPTER
18: C
ONFIGURING
C
ABLE
M
ODEM
T
ERMINATION
S
YSTEMS
Configuring Downstream Parameters
Downstream channel configuration is described in the following sections:
Annex Type
The downstream channel Annex Type parameter supports MPEG framing
format for DOCSIS and EuroDOCSIS modules. The Cuda 12000
automatically detects MPEG framing format, as follows:
■
Annex A — Indicates an MPEG framing format for a EuroDOCSIS
module.
■
Annex B — Indicates an MPEG framing format for a DOCSIS module.
Downstream Shutdown
The Downstream Shutdown parameter sets the state of the downstream
channel to up or down. Up indicates that the channel is active; down
indicates that the channel is inactive. By default, the channel should be
down, unless a prior configuration exists with the channel in the active state.
Perform the following tasks to set the downstream channel status.
Task
Command
1. Enter interface cable mode.
interface cable <c/s/i>
2. Set the downstream status to up.
downstream no shutdown
3. Set the downstream status to
down.
downstream shutdown