ADC CUDA 3 - Manual (Page 568)

ADC Telecommunications, Inc.
566 A PPENDIX A: C OMMAND S UMMARY
filter-aging {in | out} {enable | disable
| rate <seconds} slot Sets IP packet filter aging for the
module within the current slot.
import
■
router-rip
■
router-ospf
Enters import mode. From within
this mode you can create import
Routing Information Protocol (RIP)
or Open Shortest Path First (OSPF)
route filters.
ip address <ip-address> <mask>
[{other | primary | secondary}] interface:<type>:csi Adds an IP interface (IP address) to
the current physical interface. The
system supports both primary and
secondary addresses.
ip filter {in | out} {enable | disable} interface:<type>:csi Enables or disables IP packet
filtering (using access lists) on the
current interface.
ip igmp {join-group
<group-address> | query-interval
<seconds> |
query-max-response-time <seconds>
| version {2 | 1 | v2_only} | robustness
<value> | router | last-query-interval
<seconds>} interface:<type>:csi Configures the interface for IGMP
communications.
ip igmp proxy <group-address>
<group-mask> metric <number>
<c/s/i> root Configures interfaces to act as
IGMP proxies for a single multicast
group or a range of multicast
groups.
ip route <dest-network> <mask>
<gateway-ip-address> [<metric>] interface:<type>:csi Adds a static route to the current
interface. You can use this
command to add both local and
remote routes.
ip route default
<gateway-ip-address> [<metric>] Any Configures the default IP route.
ip source-route <ip address>
<mask> <next hop gateway> interface:<type>:csi Adds a source routing entry on the
current interface to ensure local
destinations are used first should
no default root exist for the
network.
map-list {route-map-list-number}
route-map
■
router:ospf:import
■
router:ospf:export
■
router:rip:import
■
router:rip:export
Adds a route-map to a specified
map-list for creation of RIP and
OSPF route filters.
Command Mode Description