ADC CUDA 3 - Manual (Page 363)

Cuda 12000 IP Access Switch CLI-based Administration Guide
Managing IGMP Interfaces 361
Displaying Groups and Parameters from Interface Mode
To display IGMP groups and interface parameters from interface mode:
Note that
■
Issue the show ip igmp groups command without specifying a group
address or an interface to display all groups on the current interface.
■
Issue the show ip igmp interface command without specifying an
interface to display details on the current interface.
See Table 17-1 for descriptions of interface details. See Table 17-2 for
descriptions of group details.
Table 17-2 Group Details
Parameter Description
Group Address The IP address of the IGMP group.
Up Time Time elapsed in hours, minutes, and seconds since the
creation of the entry.
Expires Minimum amount of time remaining before this entry is aged
out. If the value is zero, the entry does not time out.
Last Reporter Source IP address for the last membership report received for
this group IP address. If no report is received, the value is
0.0.0.0.
Status Status of the entry including:
Learned Group is learned by receiving an IGMP report over the
network
Self Group is locally joined (for example, joined manually from
the CLI)
or joined from an application on the Cuda 12000
such as OSPF or RIP.
Proxy Group is being proxied on this interface.
Task Command
1. Enter configuration mode for the
interface.
interface <c/s/i>
2. Display groups or interface
parameters.
show ip igmp groups
{<group-address> | <c/s/i>} | interface
<c/s/i>}