Packet over sonet (pos) commands – ADC CUDA 3 User Manual
Page 587
Cuda 12000 IP Access Switch CLI-based Administration Guide
Packet Over SONET (POS) Commands
585
Packet Over SONET (POS) Commands
Table A-14 POS Commands
snmp-server view <view-name>
<oid-tree> {included | excluded}
[storage {volatile | nonvolatile |
permanent | readonly}] [status
{enable | disable}]
root
Creates an SNMP MIB view.
Command
Mode
Description
Command
Mode
Description
clear counters
interface:pos:csi
Clears all counters on the current
POS interface.
clock-source {line | internal}
interface:pos:csi
Configures the SONET
transmission clock source.
crc {16 | 32}
interface:pos:csi
Configures cyclic redundancy error
checking on the current POS
interface.
loop {line | internal}
interface:pos:csi
Configures loopback testing on
the current POS interface.
mtu <value>
interface:pos:csi
Sets the maximum transmission
unit (MTU) for the interface.
pos flag {c2 | j0} <value>
interface:pos:csi
Sets values for the c2 and j0
SONET overhead bytes on the
current POS interface.
pos report lais
interface:pos:csi
Configures the POS interface to
report line alarm indication signal
errors.
pos report lrdi
interface:pos:csi
Configures the POS interface to
report line remote defect
indication errors.
pos report pais
interface:pos:csi
Configures the POS interface to
report path alarm indication signal
errors.
pos report plop
interface:pos:csi
Configures the POS interface to
report path loss of pointer errors.
pos report prdi
interface:pos:csi
Configures the POS interface to
report path remote defect
indication errors.