ADC CUDA 3 - Manual (Page 233)

Cuda 12000 IP Access Switch CLI-based Administration Guide
Creating Route Maps 231
Creating OSPF Export Route Maps
You can use OSPF route maps to permit or deny advertisement of routes
learned from a non-OSPF protocol. For example, you can choose to advertise
select routes onto your OSPF network if they were originally learned through
the RIP protocol, or if they were manually added as a static route. You can
also override the cost metric of incoming routes originating for a non-OSPF
protocol. When there are multiple routes to the same destination, the route
with the lowest cost is preferred.
OSPF export route maps are created within router-ospf export mode using
the route-map command. To create an OSPF export route map, use this
procedure:
Task Command
1. Enter router-ospf mode. router ospf
2. Enter export mode. export
3. Specify the route map that you
want to configure, or create a
new one if it does not already
exist.
route-map <map-tag> {permit | deny}